Whether to avoid using channels, on which channel availability check (listening for presence of radar signals) is required. Skip-dfs-channels ( 10min-cac | all | disabled) Leave unset (default) for automatic selection of secondary channel frequency. Secondary-frequency ( list of integers | 'disabled')įrequency (in MHz) to use for the center of the secondary part of a split 80+80MHz channel. The parameter can contain 1 or more comma-separated values of integers or, optionally, ranges of integers denoted using the syntax RangeBeginning-RangeEnd:RangeStepĮxamples of valid equency values: Leave unset (default) to consider all frequencies supported by the radio and permitted by the applicable regulatory profille. Properties in this category specify the desired radio channel.įor an interface in AP mode, specifies frequencies (in MHz) to consider when picking control channel center frequency.įor an interface in station mode, specifies frequencies on which to scan for APs.
#MIKROTIK CLIENT RADIO NAME MAC#
Defaults to the host name of the device (/system/identity).įormat for value to use in calculating the value of the User-Password attribute in AP's messages to RADIUS servers when performing MAC address authentication.įormat for the value of the User-Name attribute in APs messages to RADIUS servers when performing MAC address authentication. Value of the NAS-Identifier attribute, in AP's messages to RADIUS servers. This resolves issues with client device authentication timing out due to (comparatively high latency of RADIUS server replies.Ī unique name for the AAA profile. Length of time to cache RADIUS server replies, when MAC address authentication is enabled. Mac-caching ( time interval | 'disabled') Interval at which to send interim updates about traffic accounting to the RADIUS server. Default: II-II-II-II-II-II:Sįormat for the value of the Calling-Station-Id RADIUS attribute, in AP's messages to RADIUS servers. In a format-string, certain characters are interpreted in the following way:įormat for the value of the Called-Station-Id RADIUS attribute, in AP's messages to RADIUS servers. Properties in this category configure an access point's interaction with AAA (RADIUS) servers.Ĭertain parameters in the table below take format-string as their value. When using a CLI, wifiwave2 interfaces can be configured in the '/interface/wifiwave2' menu. When using a graphical configuration tool (WinBox or WebFig), wifiwave2 interfaces can be configured using either the 'Wireless' or 'QuickSet' tabs.
0 kommentar(er)
